Albayrak, Muhammet Gökhan; Güler, Ömer; Güler, Seval Hale; Evin, Ertan; ALMisned, Ghada; Sen Baykal, Duygu; Alkarrani, Hessa; Susoy, Gulfem; Kilic, Gokhan; Tekin, Hüseyin Ozan

This study explores the physical, structural, and radiation shielding enhancements in Inconel 718 superalloys reinforced with 1 wt% Y2O3 and varying Pr2O3 contents from 0 to 10 wt%, respectively. X-ray diffraction analysis confirmed preservation of the face-centered cubic structure, with increasing Pr2O3 inducing peak broadening and partial amorphization. The scanning electron microscopy/energy-dispersive X-ray spectroscopy results verified the homogeneous dispersion of oxides without agglomeration. Gamma-ray shielding parameters, including the mass attenuation coefficient (MAC), half-value layer, and effective atomic number, significantly improved with higher Pr2O3 content, particularly at low to mid photon energies. The 718Y-10PO sample exhibited the lowest transmission factors and the highest MAC values across all the tested energies. Buildup factors decreased in the Pr-rich samples, confirming reduced photon scattering. Notably, the fast neutron removal cross section for 718Y-10PO as 0.15521 cm−1 exceeded the benchmark materials like graphite and B4C. These findings establish the 718Y-10PO alloy as a promising candidate for advanced nuclear shielding applications, combining structural integrity with promising gamma and neutron attenuation capabilities.

İncele

Güler, Ömer; Boyrazlı, Mustafa; Albayrak, Muhammet Gökhan; Güler, Seval Hale; Ishihara, Tatsumi; Edalati, Kaveh

One of the most promising solutions to slow down CO2 emissions is the use of photocatalysis to produce hydrogen as a clean fuel. However, the efficiency of the photocatalysts is not at the desired level, and they usually need precious metal co-catalysts for reactions. In this study, to achieve efficient photocatalytic hydrogen production, a high-entropy oxide was synthesized by a mechano-thermal method. The synthesized high-entropy oxide had a bandgap of 2.45 eV, which coincided with both UV and visible light regions. The material could successfully produce hydrogen from water under light, but the main difference to conventional photocatalysts was that the photocatalysis proceeded without a co-catalyst addition. Hydrogen production increased with increasing time, and at the end of the 3 h period, 134.76 µmol/m2 h of hydrogen was produced. These findings not only introduce a new method for producing high-entropy photocatalysts but also confirm the high potential of high-entropy photocatalysts for hydrogen production without the need for precious metal co-catalysts.

AtıfScopus33·WoS30

İncele