Sürdürülebilir Kalkınma Amaçları

• 2
• 1

• MakaleAçık Erişim2024Scopus SJRQ2/r/munzur/1694
  Development of rare earth element and carbon fiber-based filler for polyethylene—Mechanical and thermal performance

  Kısmet, Yılmaz; Ayikurt, Pamuk

  In the present study, three fillers produced with carbon fiber powder (CFP) and rare earth elements were developed for low-density polyethylene production. These fillers included CFP with a grain size of less than 400 microns and over 90% pure lanthanum and cerium oxides. Polyethylene was employed to ensure the thermoplasticity and homogeneity of the fillers. The fillers were mixed with the matrix material separately, first mechanically and then homogenously in the extruder, then the test bars were produced with an injection machine. In the mechanical tests, it was determined that the tensile strength of the test bars improved by ~20% and the elastic region increased due to the increasing amount of filler. Similarly, an improvement of about 40% in bending stress was realized. In addition, as the fluidity of the mixtures has improved, it has been possible to produce at lower temperatures and save energy in the production. Thermogravimetric analysis was conducted to determine the melting/crystallization temperatures and material losses in the compounds. The scanning electron microscope analysis showed that the fillers were irregularly distributed on the surface in parallel and perpendicular directions. In addition, x-ray diffraction and energy dispersive spectroscopy analyses were performed on the surfaces.

  • 
  • 
  AtıfScopus1·WoS1·OpenAlex1

  İncele
• MakaleYalnız künye2022Scopus SJRQ2/r/munzur/2482
  Characterization of the mechanical and thermal properties of rape short natural-fiber reinforced thermoplastic composites

  Kısmet, Yılmaz; Dogan, Akar

  In this study, the effects of filler amounts were studied on the mechanical and thermal properties of high-density polyethylene (HDPE), polystyrene (PS) and polyoxymethylene (POM) polymers reinforced with short rape fibers. HDPE-rape, POM-rape and PS-rape fiber composite materials were prepared with different fiber contents and their tensile, flexural, Izod impact and TGA/DTA properties were examined. When tensile and Izod impact properties were compared, it was observed that an increase in the amount of filling in HDPE-based composites did not cause any significant changes in these peoperties, while they were decreased for POM- and PS-based composites. On the contrary to tensile and impact strengths, when the three-point flexural properties were examined, it was observed that the strength values of all these materials increased with increasing the amount of fillers. However, a pronounced increase was observed in the three-point flexural strength of the HDPE-based composite materials. The flexural strength of 30 wt% rape-reinforced HDPE composite was found to be twice that of the pure HDPE. The results of TGA and DTA analyses revealed that the reinforcement element started to burn before the matrix material and therefore burning was delayed in these thermoplastics. As a result, the mechanical properties of HDPE composite materials improved with rape reinforcement. In this way, by using approximately 30 wt% natural filling material in a polymeric matrix, an environmentally friendly material, as well as, significant advantages in cost can be obtained. Graphic abstract: [Figure not available: see fulltext.].

  • 
  AtıfScopus25·WoS25·OpenAlex33

  İncele