Yazarlar

• Al-Shamary, Adel Kadum Jassim(1)
• Arikan, Volkan(1)
• Dogan, Akar(1)
• Dogan, Tolga(1)
• Sabanci, Eray(1)

• MakaleYalnız künye2015Scopus SJRQ2/r/munzur/4390
  Effects of Temperature and Hole Drilling on Adhesively Bonded Single-Lap Joints

  Arikan, Volkan; Dogan, Akar; Dogan, Tolga; Sabanci, Eray; Al-Shamary, Adel Kadum Jassim

  In this study, the load-carrying capacity of a single-lap joint bonded by an adhesive was determined experimentally. Glass fiber-epoxy composite material was chosen as adherends and Loctite (R) 9466 A&B2 was used as adhesive. The vacuum assisted resin infusion method (VARIM) was used to manufacture composites. In this experimental study, the effects of hole drilling and temperature were investigated. Five hole configurations and three temperatures (room temperature, 50 degrees C, and 80 degrees C) were considered. The results show that hole drilling elevate the failure load and when the temperature increases the load-carrying capacity decreases.

  AtıfWoS20·OpenAlex21

  İncele