Sürdürülebilir Kalkınma Amaçları

Yazarlar

  • MakaleAçık Erişim2026Scopus SJRQ4
    Impact of Basalt Powder on the Physical, Fresh, Hardened and Microstructural Characteristics of Granulated Blast Furnace Slag-Based Alkali-Activated Mortars

    Yön, Merve Şahin; Cemalgil, Selim

    In this study, the workability, mechanical and physical aspects of alkali-activated mortar (AAM) containing basalt powder (BP) and granulated blast furnace slag (GBFS) were investigated. For the experimental study, alkali-activated mortars (AAM) containing BP at 8%, 16%, 24%, 32% and 40% substitution rates for GBFS were developed. Mortars were synthesized with a sodium silicate/sodium hydroxide ratio of 3.0 for the binder materials and a 0.45 alkali activator-to-binder ratio. The flow diameters of the fresh mortars prepared using 40x40x160 mm molds were determined according to the European Federation of Experts in Construction Chemicals and Concrete Systems (EFNARC) standard. The fresh AAMs were wrapped in stretch film to prevent evaporation and then kept in an oven at 60°C for 48 hours. The cured samples were evaluated for their mechanical strengths at 3 and 28 days, freeze-thaw effects after 33 and 100 cycles, and microstructures after 100 cycles. According to the results, using 40% BP instead of GBFS caused a decrease of approximately 15.08% in 28-day compressive strength compared to the reference sample (100% GBFS). G100 showed a minimum porosity of 15.81% and a water absorption rate of approximately 7.3%. The G60B40 mixture had the highest sorptivity capacity with 5.29x10-3 cm/s0.5, while the G100 mixture showed the lowest capacity with 3.88x10-3 cm/s0.5. After 100 freeze-thaw cycles, the G60B40 sample had the largest strength loss of 61.61%, while the G100 sample showed the lowest strength loss of 9.89%.

    AtıfScopus1
    ScopusTR Dizinİncele
  • MakaleYayıncıda açık erişim2018Scopus SJRQ1
    Investigation of usability of limonite aggregate in heavy-weight concrete production

    Esen, Yuksel; Dogan, Zulfu Murat

    Limonite (Fe2O3.xH(2)O) is a soft or brown, hard iron mineral, usually in yellow colour. It is also used as a pigment since it contains iron ore. It is believed that it can also be used in the production of heavy concrete due to its 60% iron ore content. In this paper, an experimental study was carried out on radiation shielding properties and certain physical and mechanical properties of normal and limonite reinforced concrete. For this purpose, with the normal concretes prepared according to standards, amounts of aggregates were reduced at the rates of 20%, 40%, 60%, 80% and 100% by volume respectively, and heavy concrete mixes were prepared that were obtained by adding limonite at the same rates in their place. With limonite reinforcement, compressive and flexural strength of the concrete produced decreased, water absorption amount increased and their radiation permeability significantly decreased.

    • SDG 12 · Sorumlu Üretim ve Tüketim
    AtıfWoS54OpenAlex56
    Web of Scienceİncele