Sürdürülebilir Kalkınma Amaçları
Yazarlar
Yayınlar
- MakaleAçık Erişim2024Scopus SJRQ1Changes in quality characteristics and inactivation of Salmonella in cake, including oleogel used as a fat replacer, baked with two different methods
Ozdemir-Orhan, Necla; Eroglu, Zeynep; Omac, Basri
This is the first study to assess the impact of substitution of shortening (50%) with sunflower-beeswax oleogel in cake formulations on the inactivation kinetics of Salmonella spp. and the quality attributes of cakes baked in conventional (CO) and microwave (MWO) ovens. Four distinct cake samples were examined in the study: Cake samples containing oleogel prepared in two different ovens (Oleo-Cake-CO and Oleo-Cake-MWO) and control cake samples baked in two different ovens (Cont-Cake-CO and Cont-Cake-MWO). The control-batter and oleogel-batter demonstrated shear thinning behavior (pseudoplastic, n < 1), with a good fit to the Power Law model, but viscosity and viscoelastic moduli decreased when the oleogel was used in place of shortening in cake recipes. In addition, the Cont-Cake-MWO had the greatest special volume value (2.31 ± 0.04 mL/g), whereas the Oleo-Cake-CO had the lowest (1.65 ± 0.02 mL/g) (p < 0.05). Furthermore, compared to the samples baked with CO, lower water activity and moisture values (p < 0.05) were observed in the samples baked in MWO due to their higher cooking loss values (p < 0.05). In all baking techniques, the addition of oleogel to the cake formula, used as a fat substitute, resulted in higher values for cohesiveness, hardness, springiness, and chewiness (p < 0.05). As a result, the inactivation of Salmonella in cakes slightly reduced with using oleogel as a fat substitute (p > 0.05), whereas it affected some quality properties of cakes baked with both heat treatments.
AtıfScopus4WoS4OpenAlex5
İncele - Kitap BölümüAçık Erişim2024Recent trends in evaporation techniques
Icier, Filiz; Doner, Deniz; Cokgezme, Omer Faruk; Sabanci, Serdal; Cevik, Mutlu
Increasing energy costs of the food industry and the necessity to reduce emissions of greenhouse gases orient the researchers to find alternative solutions to increase energy efficiency, and to decrease waste and environmental damage. Hence, the use of novel technologies comes to the fore. Since volumetric heating could be provided by Ohmic and microwave heating methods, a heating medium is not required. Thus it is possible to reduce undesirable changes in quality attributes by eliminating contact with hot surfaces and providing rapid heating. The negative effects on the environment could also be reduced owing to both utilization of efficient energy for the heating process and the elimination of wastewater. Alternative nonthermal methods including ultrasound, membrane filtration, pulsed electric field, and electroplasmolysis techniques could also be applied. In this chapter, recent studies on the evaporation techniques, regarding their system setups, effects on the quality characteristics, and performance evaluations are reviewed.