Yazarlar
Yayınlar
- MakaleAçık Erişim2026Scopus SJRQ2Physical and gamma-ray shielding characteristics of Copper Matrix Refractory High Entropy Alloy Reinforced Composite: an extensive experimental and computational approach
Kuluöztürk, Zehra Nur; Kuluöztürk, Muhammed Fatih; Güler, Seval Hale; Doğru, Mahmut; Güler, Ömer
Refractory High Entropy Alloys (RHEAs) have become an attractive alternative for radiation shielding applications due to their high mechanical strength, thermal resistance, structural stability, and compositional diversity. In this study, Cu-based composites containing 0–20 wt% RHEAs were prepared, and the crystal structure, morphological properties, and radiation shielding performance of the synthesized Cu-RHEA were investigated experimentally and theoretically. Measurements were performed using a NaI(Tl) detector system with point sources of 133Ba, 137Cs, 22Na and 60Co emitting gamma energies in the range of 0.356–1.333 MeV. In addition, theoretical calculations were carried out using the FLUKA and Phy-X/PSD, showing good agreement with the experimental data. Linear attenuation coefficient (LAC) values were found to decrease with increasing photon energy and to increase with increasing RHEA content. In the 0.356–1.333 MeV energy range, the experimental LAC values ranged from 0.7599 to 0.3818 cm−1 for Cu-RHEA0 and from 0.9594 to 0.4221 cm−1 for Cu-RHEA20. At 0.662 MeV, the LAC value increased from 0.5426 cm−1 for Cu-RHEA0 to 0.6183 cm−1 for Cu-RHEA20. In terms of half-value layer (HVL), the Cu-RHEA20 sample exhibited a value of 0.729 cm at 0.356 MeV, approximately 20% lower than the 0.912 cm value of Cu-RHEA0. Compared with conventional shielding materials reported in the literature, the Cu-RHEA20 sample reached a maximum mass attenuation coefficient (MAC) of 76.279 cm2⋅g−1 at 0.015 MeV, demonstrating clear superiority over ordinary concrete with a value of 7.079 cm2⋅g−1. These findings demonstrate that increasing RHEA content improves gamma-ray attenuation performance, highlighting Cu-RHEA20 as a promising next-generation shielding material.
- MakaleYalnız künye2024Scopus SJRQ1The effect of high entropy oxide on radiation shielding parameters of erbium oxide doped glasses
Kanca, M. Sait; Taşgın, Yahya; Yılmaz, Demet; Pathman, Abdul Fatah; Güler, Ömer
High-entropy materials are one of the most studied topics in recent years due to the extraordinary properties they exhibit. High entropy oxide (HEO) is a group of materials that have been studied for different applications. However, the effects of HEOs on the radiation properties of glasses are not well known. In this study, the structural, radiation and neutron shielding properties of SiO2 glass systems doped erbium oxide reinforced with refractory high entropy oxide (RHEO) with the formula TiMoNbTaWZrO11 were investigated. RHEAs used in the study were produced and characterized in our laboratory. Then, they were added to the glass samples at different rates together with Erbium oxide. As a result of SEM-EDS and XRD analyses, it was determined that the additives were distributed very homogeneously on the glass. The composition of glass systems is [95SiO2+(5-x)Er2O3+x TiMoNbTaWZrO11], where (x = 0, 0.5, 1 and 2 %, mol). The linear and mass attenuation coefficients (LAC and MAC), mean free path (MFP), half-value layer (HVL) and effective atomic numbers (Zeff) and effective electron density (Nel) of the glass structures were experimentally measured at the energy region of 53.16–661.62 keV. Also, the equivalent dose rates due to fast neutrons absorption were measured by using an 241Am–Be fast neutron source. Exposure buildup factor (EBF) and fast neutron removal cross section (ΣR) were theoretically determined. The proton and alpha shielding parameters of glasses were calculated. It is observed that glasses containing higher amounts of refractory high entropy oxide, within the SiO2–Er2O3 composition, demonstrated enhanced capabilities for shielding against radiation and neutrons.
AtıfScopus15WoS15OpenAlex17
İncele - MakaleYalnız künye2024Scopus SJRQ1Influence of praseodymium oxide on the structural, mechanical and photon, charged particles, and neutron shielding properties of alumina borate glass
Acikgoz, Abuzer; Izguden, Ilyas; Tasgin, Yahya; Yilmaz, Demet; Demircan, Gokhan; Kalecik, Sedanur; Aktas, Bulent
The structural, mechanical and radiation shielding properties of (69-x)B2O3-20TeO2-10Al2O3-1HfO2-xPr6O11 (where x = 0, 0.25, 0.5, 0.75, 1 mol %) glass system were investigated. This study introduces a novel approach by incorporating Pr6O11 into glass composition, highlighting its unique contributions to enhancing elastic properties, fracture toughness, hardness, and radiation shielding abilities. Experimental measurements were conducted within the energy range of 59.54–661.62 keV and theoretical calculations are made for MAC values. The presence of Pr6O11 was noted to positively influence the gamma shielding capabilities. At 59.54 keV, the addition of 0.25 mol% Pr6O11 increased the mass attenuation coefficient of the glass by 2.9 %, and the addition of 1 mol% Pr6O11 increased it by 29.8 %. The addition of 0.25 mol% Pr6O11 increased the fast neutron removal cross section of the glass by 4.4 %. Also, it is observed that the glass with 1 mol% Pr6O11 is the best shielding material against alpha and proton particles. A significant enhancement of 24.36 % in the fracture toughness value was observed, increasing from 1.059 to 1.317 MPa m1/2 at 1 mol% Pr6O11. Experimental hardness values increased from 3.374 to 3.985 GPa, resulting in an improvement of 18.11 % at 1 mol% Pr6O11. The thermal stability (ΔT, °C) value demonstrated a notable increase from 85 to 106, indicating a significant 24.7 % improvement at 0.25 mol% Pr6O11.
AtıfScopus58WoS57OpenAlex60İncele