Sürdürülebilir Kalkınma Amaçları
Yazarlar
Yayınlar
- MakaleYalnız künye2026Scopus SJRQ2Comparative Analysis of Sequential Electrooxidation and Electrocoagulation Processes for Leachate Treatment
Ogedey, Aysenur; Oguz, Ensar
This study aims to improve the removal efficiency of chemical oxygen demand (COD), NH₃-N, and turbidity from Bingöl leachate through a sequential electrochemical process. This process includes electrooxidation (EO) with Ti/PdO-CoO anodes and stainless-steel cathodes, followed by electrocoagulation (EC) with aluminum anodes and stainless-steel cathodes. The sequential electrochemical process lasted 400 min, consisting of 360 min of EO followed by 40 min of EC process. At pH 5, COD and turbidity reached optimal removal efficiencies of 89% and 99.9%, respectively, while NH₃-N achieved 88.5% at pH 9.5. These results indicate that the sequential electrochemical process was most effective under these pH values for removing organic matter, nitrogen, and suspended solids. The sequential electrochemical process led to significant improvements in the removal efficiencies of COD, NH₃-N, and turbidity, with increases of 32.5%, 44%, and 6.9%, respectively, compared to the EO process. The sequential electrochemical process showed improvements of 9.5% in COD and NH₃-N removal, and 1.2% in turbidity removal, compared to the results of the EC process. The pseudo-first-order (PFO) reaction rates for the EO and EC processes were determined, resulting in high R2 values (0.98–0.99). Additionally, the total consumption cost of the EO process was higher than that of the EC process. After the sequential electrochemical process, the consumption cost increased from $13.586/kg COD to $24.332/kg COD as the current density increased from 15 mA/cm2 to 25 mA/cm2.
AtıfScopus1WoS1OpenAlex1
İncele - MakaleAçık Erişim2026Scopus SJRQ1RGO-CBPAC versus CBPAC for diluted leachate treatment: adsorption isotherms, kinetics and thermodynamics
Ogedey, A.; Oguz, E.
This study compares carbon-based activated carbon (CBPAC) and reduced graphene oxide-modified CBPAC (RGO-CBPAC) for removing COD, NH3–N, and turbidity from 1:4 diluted leachate from the Bingöl landfill site. Brunauer Emmett Teller (BET) analysis indicated severe micropore blockage in CBPAC after adsorption (887 → 0.76 m2/g), whereas RGO-CBPAC retained a higher surface area (908 → 23 m2/g) and mesoporous structure, demonstrating enhanced structural stability due to graphene incorporation. Fourier-transform infrared spectroscopy (FTIR) and scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM–EDX) confirmed the presence of surface functional groups and effective pollutant uptake, with RGO-CBPAC showing stronger surface–pollutant interactions. Zeta potential analysis showed pH-dependent surface charge behaviour, with CBPAC exhibiting amphoteric characteristics and RGO-CBPAC maintaining a more negative surface. After adsorption, both became more negatively charged, indicating the accumulation of negatively charged species. Kinetic analysis showed that COD adsorption on CBPAC followed pseudo-first-order and intraparticle diffusion models, whereas NH3–N and turbidity followed pseudo-second-order kinetics. In contrast, RGO-CBPAC exhibited pseudo-second-order and intraparticle diffusion behaviour for all pollutants, suggesting chemisorption with diffusion-controlled contributions. Adsorption equilibrium was best described by the Langmuir isotherm, yielding maximum capacities of 500 and 588 mg O2/g for COD, 17.5 and 36.5 mg/g for NH3–N, and 18.1 and 58.5 mg/g ((NH2)2H2SO4)/g for turbidity on CBPAC and RGO-CBPAC, respectively. Thermodynamic analysis demonstrated that COD and turbidity removal using RGO-CBPAC were spontaneous (∆G° < 0) and endothermic (∆H° > 0), whereas NH3–N removal remained non-spontaneous for both adsorbents. RGO incorporation significantly enhanced adsorption performance.
AtıfScopus1WoS1OpenAlex1İncele - MakaleAçık Erişim2024Scopus SJRQ1Application of electrocoagulation process for the disposal of COD, NH3-N and turbidity from the intermediate sanitary landfill leachate
Ogedey, Aysenur; Oguz, Ensar
This study aims to determine the COD, NH3-N and turbidity disposal efficiencies from leachate in the Bingöl landfill and highlight the electrocoagulation (EC) process’s performance in removing these pollutants. After establishing that landfill leachate was intermediate aged, its characteristics were identified using physical, chemical and elemental analyses. Six parallel-connected electrode plates with stainless steel as the cathode and aluminium as the anode were used to construct an electrocoagulation cell. After a 40-min treatment interval, the optimal disposal efficiencies for COD and turbidity from the leachate were determined to be 87% and 62%, respectively, at pH 5. Following a 40-min reaction, BOD5 concentration and BOD5/COD ratio were determined to be 85.75 mg O2/L and 0.64, respectively, at pH 5. At a NaCl concentration of 10 mM, the optimum disposal efficiency for NH3-N was determined to be 33%. The reaction kinetics matched pseudo-first-order (PFO) kinetics due to high correlation coefficients (R2 = 0.93–0.99) in removing COD, NH3-N and turbidity under different experimental conditions. The optimal reaction rate constants were determined as 2.93 × 10−2 min−1, 1.92 × 10−2 min−1 and 7.3 × 10−3 min−1 for the disposal of COD, NH3-N and turbidity, respectively. Energy consumption, unit energy consumption and total consumption cost rose in the EC process when the current density was augmented from 15 to 25 mA/cm2.
AtıfScopus14WoS11OpenAlex12
İncele - MakaleYalnız künye2018Scopus SJRQ2Comparison of Some Soil Fungi in Bioremediation of Herbicide Acetochlor Under Agitated Culture Media
Erguven, Gokhan Onder
In this study, we aimed to find out the biodegradation efficiency of some soil fungi types on herbicide acetochlor with acetochlor active material, chemical oxygen demand (COD), biochemical oxygen demand (BOD5) and total organic carbon (TOC) parameters. We also try to determine the population dynamics of these fungi via turbidity. The fungi cultures were isolated from agricultural field in in Thrace region of Turkey. Each fungi enriched in malt extract broth media and 1 mL of these enriched media was inoculated into 100 mL of acetochlor solutions that suggested for using application concantrations in agricultural field for farmers (11000 mg L−1) for sunflower and corn agriculture. Bioremediation results of acetochlor have shown different results according to the types of fungi. Our results indicate that Tolypocladium geodes and Cordyceps cicadae might be used in acetochlor bioremediation with a significant acetochlor, COD, TOC and BOD5 reduction and can be used for rehabilitation of agricultural fields or receiving environments for removal the opposite effects of acetochlor or other herbicides.
AtıfScopus37WoS26OpenAlex36İncele - MakaleYalnız künye2016Scopus SJRQ3Efficiency of some soil bacteria for chemical oxygen demand reduction of synthetic chlorsulfuron solutions under agiated culture conditions
Erguven, G. O.; Yildirim, N.
This study searches the efficiency of certain soil bacteria on chemical oxygen demand (COD) reduction of synthetic chlorsulfuron solutions under agitated culture conditions. It also aims to determine the turbidity of liquid culture medium with chlorsulfuron during bacterial incubation for 120 hours. As a result the highest and lowest COD removal efficiency of bacteria was determined for Bacillus simplex as 94% and for Micrococcus luteus as 70%, respectively at the end of the 96th hour. It was found that COD removal efficiency showed certain differences depend on the bacterial species. It was also observed that B. simplex had the highest COD removal efficiency and it was a suitable bacterium species for bioremediation of a chlorsulfuron contaminated soils.
AtıfWoS24OpenAlex3İncele